MS密封膠的硬度拉斷伸長率剝離強度和力學性能測試

發布時間 : 2026-7-15 12:04:05
Views:

(Summary description)Customized SILICONE STRUCTURAL SEALANT from China manufacturer refers to the adhesive with high strength, can bear large load, aging resistance, fatigue resistance and corrosion resistance, and has stable performance within the expected life. It is suitable for bearing the bonding of strong structural parts. Non structural adhesive has low strength and poor durability. It can only be used for bonding, sealing and fixing of ordinary and temporary properties, and cannot be used for structural adhesive bonding. NEUTRAL SILICONE WETHERPROOF SEALANT from China manufacturer is a structural adhesive with waterproof function. Silicone glue refers to the adhesive based on silicone rubber. According to different functions, it can be divided into structural adhesive, potting adhesive, sealant, thermal conductive adhesive, flame retardant adhesive and so on.

MS密封膠的硬度拉斷伸長率剝離強度和力學性能測試

發布時間 : 2026-7-15 12:04:05
Views:

Information

常溫力學性能測試依據GB/T 531.1-2008((硫化橡膠或熱塑性橡膠壓人硬度試驗方法》，GB/T528-2009《硫化橡膠或熱塑性橡膠拉伸應力應變性能的測定》，HB5249-1993《室溫硫化MS密封膠180。剝離強度試驗方法》，分別取用120號汽油與壬烷作為溶劑，按照相同組分配比，制備兩組HM301刷涂型MS密封膠MS密封膠:MS密封膠①刷涂型HM301(120號汽油溶劑)、MS密封膠②刷涂型HM301(壬烷溶劑)。對兩組MS密封膠的硬度、拉斷伸長率、剝離強度和拉伸強度[4]進行對比測試，測試結果見表。其中，硬度、拉(扯)斷伸長率與拉伸強度兩組MS密封膠幾乎完全一致，且滿足Q/6S 1688-2013 ((HM301室溫硫化耐高溫有機硅MS密封膠規范》。而MS密封膠①的剝離強度為4.SkN/m，MS密封膠②的剝離強度為3.6kN/m，均大于企標規范的1.SkN/m，符合工藝要求。結合宏觀形貌分析，MS密封膠②(壬烷溶劑)剝離強度較低，原因?yàn)槿赏榈膿]發速率對比120號汽油較慢，HM301MS密封膠硫化過程中，在MS密封膠內部形成微量間隙，從而降低了剝離強度。這與“脂肪烴分子碳原子上升，閃點相應上升，但揮發性相應下降”的原理是相適應的。熱空氣老化性能測試按HB 5247-1993《室溫硫化密封劑熱空氣加速老化試驗方法》，分別取用120號汽油與壬烷作為溶劑，按照相同組分配比，制備兩組HM301刷涂型MS密封膠MS密封膠:①刷涂型HM301(120"汽油溶劑)、②刷涂型HM301(壬烷溶劑)。經(250士5)℃/100h老化對兩組MS密封膠的剝離強度進行對比測試，測試結果見表。http://www.mychangxin.com/

Scan the QR code to read on your phone

上一篇: 丁基防水嵌縫膠會發生熱氧化老化現象

下一篇: 丁基防水嵌縫膠微觀形貌與成分分析

上一篇: 丁基防水嵌縫膠會發生熱氧化老化現象

下一篇: 丁基防水嵌縫膠微觀形貌與成分分析